FRP for Mining: Abrasion as Well as Corrosion

Mining is the industry where FRP has to survive two attacks at once. Most plants worry about corrosion. A mine worries about corrosion and abrasion, and they are different problems with different answers.

Abrasion is not corrosion

Corrosion attacks chemically and fairly evenly across the wetted surface. Abrasion attacks mechanically and unevenly: it concentrates on the outside of every bend, at every change of direction, and wherever flow slows enough for solids to drop out.

A resin chosen purely for acid resistance can be worn through at an elbow while the straight run beside it is untouched.

If your line carries solids, three numbers change the design:

  • Solids content, by weight or by volume.
  • Particle size, and whether the particles are angular or rounded.
  • Flow velocity. Too slow and solids settle; too fast and abrasion accelerates sharply.

The answer can be a sacrificial internal layer, a different resin, a larger radius on the bends, or a planned rotation schedule for elbows. All of them are cheaper decided before manufacture.

Where FRP goes in a mine

  • Leach and thickener tanks, where acid and slurry meet.
  • Slurry and tailings piping, instead of rubber-lined or hardened steel.
  • Process and raw water tanks, often the largest equipment on site.
  • Reagent storage — sulphuric acid, cyanide solutions, flocculants.
  • Walkways and platform grating, where spillage kills steel grating fast.
  • Scrubbers and ducting for acid mist and dust extraction.

A remote site changes the arithmetic

A mine is usually a long way from a fabrication shop, and that changes what a material really costs:

  • Weight is freight. FRP is a fraction of the weight of steel, and on a mountain road that is a real number rather than a talking point.
  • Replacement is not a purchase, it is a mobilisation. Getting a crane, a crew and a replacement vessel to a remote site costs more than the vessel. Equipment that lasts is worth more where access is hard.
  • Field repair matters. FRP is repaired by laminating, with no hot work permit, which is a genuine advantage inside an operating plant.

What to send us

  • The slurry or solution — chemical, concentration, and the solids content, particle size and velocity if it carries solids.
  • Temperature, operating and maximum.
  • Specific gravity. Mineral slurries are heavy, and this drives the structural design far more than most buyers expect.
  • Site altitude and location, for seismic and wind loading and for transport planning.
  • Access, including road limits, because that can decide whether a tank ships in one piece or in sections.

Contact a sales engineer

Choose your preferred contact method

Posted on • by PITSA FRP