FRP for Construction and Infrastructure

This is the one industry on the list where FRP is chosen for what it is not: not conductive, not magnetic, not something that has to be recoated, and not something chlorides can touch.

Where steel stops making sense

Galvanized steel is an excellent, cheap material, and for a dry indoor walkway it is the right choice. We would rather say that than sell you the wrong product.

It stops making sense where:

  • The site is coastal. Salt air ends galvanizing far faster than the brochure suggests, and the failure starts at cuts, welds and edges — the places installation created.
  • The structure is over water or in a wash-down area, permanently wet.
  • Recoating means a shutdown. In a live plant, the cost of maintaining a coating is the access, not the paint.
  • Conductivity is a hazard. Around electrical equipment, substations, cathodic protection or high-voltage work, a non-conductive walkway is a safety decision, not a preference.

Molded grating for real-world geometry

PITSA manufactures molded FRP grating, whose strength is uniform in every direction. That matters on a construction site more than in a catalogue, because panels get cut to fit around pipe penetrations, equipment already installed, and openings that are never a tidy rectangle.

Pultruded grating carries load along its bars, so cutting across them removes the strength. Molded grating keeps behaving like grating after a cut.

We do not manufacture steel grating.

Two field rules that decide the outcome

  • Seal every cut edge with resin. A cut exposes the glass. In a wet or coastal environment an unsealed edge wicks moisture into the laminate and the panel degrades from the cut inward, while the rest stays perfect. It takes minutes, and it is the most common avoidable failure.
  • Use hold-down clips, not bolts through the bearing bars. Drilling a bearing bar removes exactly the material carrying the load.

Typical applications

Pedestrian walkways and platforms, trench and drainage covers for pedestrian and vehicular loads, stair treads and landings, handrail and structural sections, covers over channels and pits, and access platforms around industrial equipment.

What to specify

  • The environment — coastal, wash-down, chemical spill, or dry.
  • The load — pedestrian, cart, or vehicle, and any point load.
  • The clear span between supports. Load and span together set the panel depth, and depth is the biggest driver of cost.
  • The layout, with cut-outs and penetrations marked.
  • Anti-slip surface, which outdoor and wash-down areas need.
  • Any flame-spread requirement from the plant or the insurer.
  • Colour, if it matters for safety marking.

If you are replacing corroded steel grating, say so — the existing opening sizes and support spacing usually answer most of the above already.

Contact a sales engineer

Choose your preferred contact method

Posted on • by PITSA FRP